|Post 1 made on Tuesday March 6, 2018 at 10:04|
I can't get my 9800 to connect to my WiFi network.
I have an AP set to 2.4GHz, 802.11b/g/n and WPA2 encryption.
I'n PEP3 I specified the SSID, WPA/WPA2 encryption and the network key.
But the device is stuck on "Connecting...".
Are there any legacy settings I need to enable on the AP side?
|Post 2 made on Tuesday March 6, 2018 at 23:07|
I have a Netgear AP set to "Enable 20/40 MHz Coexistence" to provide single channel legacy support. I also have configured the Mode setting of "Up to 54 Mbps". For security, I use the option "WPA-PSK [TKIP] + WPA2-PSK [AES]"
As far as getting stuck on connecting, my 9800s can sometimes take a several minutes to establish a connection.
|OP | Post 3 made on Wednesday March 7, 2018 at 03:33|
I finally managed to get a connection, limiting my AP to only WPA encryption.
With WPA+WPA2 or WPA2 only it didn't connect.
Is the 9800 (latest beta firmware) supposed to do WPA2 too or am I stuck with WPA?
Does anyone know?
|Post 4 made on Wednesday March 7, 2018 at 21:52|
WPA2 wasn't initially supported. I'm using WPA2 with the latest firmware 7.4.22 and PEP-3 (PEP-2 should also provide support). You should see it as an option within the Network tab of your System Properties screen.
|OP | Post 5 made on Thursday March 8, 2018 at 05:43 |
Thanks for the confirmation!
I'll try to find the right settings then, to make WPA2 work.
Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.