|Post 1 made on Wednesday September 28, 2011 at 15:57|
Hi guys, New house, buyer wanted my older TV's and such. Starting fresh. 60" Aquos ATT uverse. HDMI connected. I was able to get the ATT remote to work the TV, but some of the commands don't work. I have used the $30 sony programmable in the past, but would like to use only the sharp remote if I can. I have tried pretty much all the codes listed in the manual and more to no avail.
The codes they say are only 2 digit codes. I tried from 01- 38 no dice. Choose devise and while holding it push display/ flashes then stops after code..
If anyone has any ideas I would appreciate it. I have even gotten the netflix and such working fine through the TV wifi.
It says Cisco on the front of the STB uverse box. If that helps
Thanks , Steve
|OP | Post 2 made on Monday October 3, 2011 at 12:52 |Please read the following:
Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our Marketplace
. For information on how to advertise your service or product click here
. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.