Post 1 made on Saturday June 16, 2012 at 22:59 |
69VanNuys Long Time Member |
|
|
Any ideas on why a learned button on a MX-980 works in Test Mode when connects to CPP, but does not work when remote is stand alone?
|
|
Post 2 made on Sunday June 17, 2012 at 23:50 |
Mario Loyal Member |
Joined: Posts: | November 2006 5,681 |
|
|
Have you downloaded it to the remote?
|
|
|
Post 3 made on Monday June 18, 2012 at 13:54 |
Tom Ciaramitaro Loyal Member |
Joined: Posts: | May 2002 7,958 |
|
|
Double click the command in the macro window and look for the checkbox "repeat while pressed" or similar.
In macros you sometimes have to uncheck it and set the delay.
|
There is no truth anymore. Only assertions. The internet world has no interest in truth, only vindication for preconceived assumptions. |
|
OP | Post 4 made on Sunday June 24, 2012 at 00:40 |
69VanNuys Long Time Member |
|
|
As it turns out, when I learned the code, the RF and IR where reset to only allow IR. Now that RF is on, it works. Thank you to URC for that check.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.