Post 1 made on Sunday October 15, 2006 at 10:13 |
1ziggi1 Long Time Member |
Joined: Posts: | September 2006 410 |
|
|
How do you make a power on-off button to take the remote to standby mode?
Last edited by 1ziggi1
on October 17, 2006 09:04.
|
|
Post 2 made on Monday October 16, 2006 at 13:21 |
cgroth Founding Member |
Joined: Posts: | April 2002 475 |
|
|
I don't think that possible.
|
|
OP | Post 3 made on Tuesday October 17, 2006 at 09:08 |
1ziggi1 Long Time Member |
Joined: Posts: | September 2006 410 |
|
|
It must be because when I purchased this remote it had a button on the screen that did just that. Unfortunately I didn't save the rcc file before overwriting it.
|
|
Post 4 made on Tuesday October 17, 2006 at 16:39 |
GregoriusM RC Consultant |
Joined: Posts: | December 1999 9,807 |
|
|
There is nothing in the software that supports this.
|
When ignorance is bliss, ‘tis folly to be wise. |
|
Post 5 made on Thursday October 19, 2006 at 01:28 |
Dave E Long Time Member |
Joined: Posts: | September 2005 282 |
|
|
Are you asking about the Sleep Timer described on page 16 of the programming manual? This will power the system down in 15,30, 60 or 90 minutes.
|
Experience is what you get when you don't get what you want. Any wire cut to length will be too short. I must be a near GENIUS. All my teachers told me I was at the very PEAK of the bell curve! |
|
Post 6 made on Saturday October 21, 2006 at 02:32 |
techman707 Lurking Member |
Joined: Posts: | October 2004 9 |
|
|
Maybe what you're looking for is the settings page, which you can bring up by holding the "MAIN" button down for 10 to 15 seconds to bring it up.
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.