Your Universal Remote Control Center
Philips ProntoNEO Family Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Monday June 1, 2009 at 21:25
Long Time Member
September 2002
Ok, I've created the startup page and had Power and TV Power macros on the startup page, and on each device page (all were programmed so that Power turned everything on and TV Power turned everything off). This all worked until I used NeoSync to set the Startup page as the Device page. When I did this, I lost the Power and TV Power macros on all device pages including the Startup page. The programming still shows on the PC but I do not get the IR symbol in the upper right corner of the remote when one is pressed. Anyone else have this problem?

Hosting Services by ipHouse