Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 4 made on Sunday September 10, 2006 at 11:16
Long Time Member
January 2005
On a MRF-300 I have one port that has 10 emitters all wired in parallel using 3.5 mm plug splitters and one custom made hub. All controlled components work fine. Each device uses an emitter and is programmed to a specific port. About 25 devices total on one MRF-300.

Not sure why Eric recommends wiring only in series and not parallel? Also remember this piece of advice I learned long ago - one test is worth a thousand opinions.

I've had bad experiences using MRF-250 especially with power macros. Replacing with MRF-300 will help.

Hosting Services by ipHouse