Post 1 made on Monday September 4, 2006 at 19:06 |
limoman Long Time Member |
Joined: Posts: | August 2006 12 |
|
|
I'm using the URC-300 with the MRF-100 Expander located in my equipment cabinet. Everything is working as it should except for controlling my TiVo. It appears that the URC-300 is not learning the TiVo codes properly. I tried powering off the MRF 100 and pointing the URC-300 directly (line of site - about 10 feet) at the Tivo and I get nothing. The TiVo remote works without a problem, but the URC-300 doesn't.
I had read thatTiVo's require less of an IR signal - some suggest taping over the TiVo sensor, moving the emitter, etc. Nothing has worked. Again, because I can not even get the TiVo to respond from the URC-300 when I point it directly at it, I'm assuming the 300 is not learning the commands.
Can anyone offer any help?
Thanks,
Ed
|
|
|