Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Saturday October 14, 2006 at 13:07
Long Time Member
November 2004
I live updated both my MSC-400 and MX-3000, loaded as test file for woring w/ a USB keyboard (didnt work), reloaded my production version and now NO COMMANDS ARE BEING RECEIVED BY THE MSC-400!!! I have a total BOAT ANCHOR for a remote.

I got a new error when downloading to the MSC-400: "You are connected to an RF1WAY-Micom version, if you need to set two RFID# for an MX-950 or MX-3000 , you must use an RF1WAY-Micom version However, if oyu are using an MX-900 or TX-1000 , you can simply use RFID#s from ID#10 to 1F to address IR outputs 7-12"

I have 12 devices all routed via RF due to very noisy IR/RF conditions. Devices 7-12 were assign line id 1-6 (overlaping deives 1-6) per URC's recomendation due to the MX-3000 Editor not yet being able to support RF ID above F. This was all working perfectly, now I'm dead in the water, with now way to control this system without completely reprogramming...

Any help?

Hosting Services by ipHouse