On 10/13/05 01:26 ET, DanKurts said...
Peter
That makes sense, except it works fine on the
new pcf, with or without other commands in the
SAME macro. Same hex code on the buttons of either
old or new pcf. Old pcf only works with the one
command.
That's what's so wierd.
Is there any other possibile cause, besides the
software?
Since others have had a similar result, I'm going
back to the last version firmware and see what
happens.
I'll let you know what happens.
Dan
Update
Reloaded the older 3.7.7 into the 7000, used the new editor version 2.1.4.0, loaded the same old non working pcf, BOOM! Works like champ. Has all 4 original steps to the macro and a jump. Obviously something going on with this update. I can send the pcf's to the guru's, just need to know where.
Meanwhile, going back to my customers and change their firmware back. Isn't this fun, lots of driving, and with the price of gas being soooo reasonable..........arrrrrr.
Think I'll throw some Blues music in the van!
Dan