Post 1 made on Monday September 25, 2006 at 10:07 |
Photis Hadjicostis Founding Member |
|
|
Hi there,
When I use the original remote control to learn a new command to iPronto, the iProntoEdit software assigns the "Learned IR code" name to the command. My intention was to remane every command to a more logical one such as "TV Power On". When I do that however and exit iProntoEdit when I run the program again my assigned name disappears and the generic "Learned IR code" name appears again. So I end up with a series of commands with the same name and I do not know which is which. Anyone experienced this? Is there a solution?
Thanks
|
|
|