The following page was printed from RemoteCentral.com:
Post 2 made on Monday January 14, 2002 at 11:33 |
Buster Founding Member |
Joined: Posts: | November 2001 5 |
|
|
I fixed the problem by turning off the UART FIFO (setting both XMIT and RCV to 1) in SETTINGS-CONTROL PANEL-SYSTEM-DEVICE MANAGER-PORTS-COM1-PORTS SETTINGS-ADVANCED. I also set the default speed to 115200 and flow-control to NONE (I don't think these would make any difference since the software should setup these port parameters).
I hope this helps others (assuming this actually fixed the problem permanently).
|
|
|
|