Your Universal Remote Control Center
RemoteCentral.com
Philips Pronto Classic Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 1 made on Monday June 9, 2003 at 19:56
John@MHF
Lurking Member
Joined:
Posts:
June 2003
2
I have a list of RC5 codes from Primare, but can't seem to input them into ProntoEdit 4.0. Anyone know how I can get these RC5 codes to work? Or better yet, how to read all this stuff? Any help would be GREATLY appreciated! Thank you in advance.




Here's what I received from Primare:

I20 Remote Control Commands.

RC5 address = 20 (0x14)
bits:
0x0500 = 0000 0101 0000 0000 (=1280)
xxxx tsss ssdd dddd
(s ssss = 1 0100 = 0x14 = 20)

x=not used
t=toggle bit
s=system bits (address)
d=command (VALUE below)

short press (default) = 1 command.
long press = 3 consecutive identical commands


KEY VALUE ACTION

standby 12 (0x0c) Standby ON (common)

standby 1 (0x01) Standby ON (unique)

operate 2 (0x3a) Operate (Standby OFF)

step up 30 (0x1e) Next input

step down 31 (0x1f) Previous input

input mode 26 (0x1a) toggle input mode (balance, master volume)

mute 49 (0x31) Toggle mute on/off

plus 16 (0x1e) Increase/change master volume and balance

minus 17 (0x1f) Decrease/change master volume and balance

dim 10 (0x0a) Toggle display on/off


1 60 (0x3c) Used for main input selection
2 61 (0x3d) Used for main input selection
3 62 (0x3e) Used for main input selection
4 63 (0x3f) Used for main input selection



For complete command, just add system address value 1280 with key value 1 (for standby) = 1281 (0x0501).



Hosting Services by ipHouse