Your Universal Remote Control Center
RemoteCentral.com
Lighting & Home Control Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 2 made on Tuesday May 4, 1999 at 11:27
Robert
Historic Forum Post
To get started using your Pronto you need to purchase a transceiver. This product converts the Pronto IR signals to an X-10 coded signal that will be sent down your home's AC powerline. Now, you need something connected to the powerline that will receive the signal and do something, like turn on a light. These devices are X-10 receivers and come in many varieties. The most common type of X-10 receiver is the type that controls a plug in lamp, or a switched light.

Since you mentioned that you have lamps that are plugged in, you would need an X-10 lamp module. There are two types available. Of the two I highly recommend the type that has a "soft start" feature and "memory dim", and "Automatic Gain Control". This type of lamp module is more expensive than the standard type but the features are well worth it.

"Soft Start" brightens the light from Off to On over a 1-2 second period saving your eyes and light bulbs. It dims to Off over a 1-2 second period when you turn the light off.

"Memory Dim" memorizes the last dim setting your lamp was at when you turned it off. It will resume to that dim level when you turn the lamp back on. Lamp modules that doen't have this feature go immediately to 100% brightness first, and then you can dim them down to a lower level.

"Automatic Gain Control" is extra electronics that improve the module's sensitivity to X-10 transmissions. This can save you a lot of frustration that you may experience with modules that doen't have this feature. AGC can compensate for electrical noise on your AC power line that interferes with X-10 signals.

To turn lights on/off or dim/bright you only need your Pronto, a transceiver, and lamp or light switches. You do not need an Active Home (or similar) computer interface. You can also create lighting scenes with your Pronto by creating a macro that sends a combination of X-10 on/off/dim commands to different lights or lamps. So by pressing one button on your Pronto, you could adjust the light level of as many lights as you like!

Please send me an e-mail if you have any questions or would like to order the equipment you need to get you started. By the way, X-10 light switches have even more options to consider so please contact me or someone qualified in this area before you purchase.

Robert
RCI Automation
[Link: ourworld.compuserve.com]


Hosting Services by ipHouse