Your Universal Remote Control Center
RemoteCentral.com
Blu-ray & DVD Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 6 made on Tuesday April 11, 2006 at 18:48
Lowpro
Select Member
Joined:
Posts:
March 2004
2,054
On April 11, 2006 at 10:03, ceylonfan said...
Do you know of a resource for Sony 995v discrete
IR codes?

I have a full set of IR codes for each Command Mode, including discrete power on and off codes. While these codes are for my 985 changers, the 995 uses the same IR codes. There may be a few new IR codes for the 995 I'm not aware of. I'm not sure about that, but my codes will certainly get you 99% of the way there. Below in my signature area is a link to my PCF download post. When downloading and opening my PCF the Sony codes for Command Modes 1-3 can be found in the last section of the device tree called, "Pronto Signals". The names of the specific devices are listed below.

Pronto Signals (Sony DVP-CX985V (DVD 01) / CM1 / RF / ID1)
Pronto Signals (Sony DVP-CX985V (DVD 02) / CM2 / RF / ID1)
Pronto Signals (Sony DVP-CX985V (DVD 03) / CM3 / RF / ID1)


The "CM" designation in each device name calls out the Command Mode for said codes. If you happen to copy any of these devices to your PCF make certain to adjust the RF tab accordingly based on your own physical setup.

Last edited by Lowpro on April 11, 2006 23:22.
LP Related Links:
View my profile to access various
links to key posts and downloads.


Hosting Services by ipHouse