Your Universal Remote Control Center
RemoteCentral.com
Audio, Receivers & Speakers Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 32 made on Wednesday January 26, 2005 at 15:41
RayNix
Lurking Member
Joined:
Posts:
February 2003
8
I have been using a Kenwood VR-509 reciever for 2 1/2 years now without any problems.
For what it is worth, I didn't like the remote that came with the VR-509 and switched to a Sony RMAV3000 and changed over to IR only.

The Kenwood remote does both IR and RF...RF needs an antenna (page 19 of manual)
The remote can be set to send only IR...this is what I did before learning IR codes with my RMAV3000.
The switch is under the battery cover in the top right...there are 3 settings: 1) RF Band1, 2) RF Band2 and 3) RF Off.
The next "trick" is that the receiver needs to be set the same way.
Press and hold the SET UP key on the front panel of the VR-509 receiver for more than 2 seconds and release. After that, each time you press the SET UP key, the RF reception frequency changes as follows: 1) RF Band1, 2) RF Band2 and 3) RF Off.
Match the Kenwood remote and the VR-509.

Beyond that, I would guess that there is a problem with the amps receiver.


Hosting Services by ipHouse