Your Universal Remote Control Center
RemoteCentral.com
Philips Pronto Classic Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 22 made on Friday February 9, 2007 at 12:48
sport
Founding Member
Joined:
Posts:
October 2001
103
On October 1, 2006 at 20:29, ahperry said...
Here's the list (not the original poster, but I have the
information):

Applicable Remote Controls and Televisions
This document applies to the full size television remote
controls introduced in 2006. The inputs specified below
apply to the TVs that included these remotes. If a model
does not have the specified input, or there is no connection
to the specified input, the TV will not respond to the
direct access signal. The 731 series TVs have a PC DVI-I
input, however these models do not respond to the PC DVI-I
access signal.

Procedure to program the remote for special direct
access functions:


  1. Set the Device Select Switch at the top to the TV
    position.

  2. Press and hold the POWER key until it flashes twice,
    then release the POWER key.

  3. Enter in sequence the code number 0,0,0,9,0. The
    POWER key will flash twice after the first 0 and then
    flash twice again after the final 0 to confirm a successful
    code entry.


The following keys will change functions:
POWER - Power ON only.
STOP - Power OFF only.
PAUSE - AV RESET (resets audio and video adjustments).

INPUT followed by 1 - INPUT-1
INPUT followed by 2 - INPUT-2
INPUT followed by 3 - INPUT-3
INPUT followed by 4 - HDMI 2
INPUT followed by 5 - COMPONENT-1
INPUT followed by 6 - COMPONENT-2
INPUT followed by 7 - COMPONENT-3
INPUT followed by 8 - ANT 2
INPUT followed by 9 - ANT 1
INPUT followed by F1 - HDMI 1
INPUT followed by F3 - PC DVI-I Input (not available for
731 series)

FORMAT followed by 1 - STANDARD screen format
FORMAT followed by 2 - EXPAND screen format
FORMAT followed by 3 - ZOOM screen format
FORMAT followed by 4 - STRETCH screen format
FORMAT followed by 5 - STRETCH PLUS screen format
FORMAT followed by 6 - NARROW screen format
FORMAT followed by 7 - WIDE EXPAND screen format

IMPORTANT: When using this remote control as
an original source remote control to program a "learning"
remote control or Home Automation control system
,
the INPUT and FORMAT keys do not send signals. These
buttons are simply used as a "switch" function to prepare
the remote control to send the correct input or format
signal when the number key or other specified key is pressed.

IMPORTANT: This remote control was included with
TVs that had Auto Input Sensing. Direct access to inputs
that have not been connected and added to the active input
list is not possible.

Procedure to return the remote control to normal consumer
functions:


  1. Set the Device Select Switch at the top to the TV
    position.

  2. Press and hold the POWER key until it flashes twice,
    then release the POWER key.

  3. Enter in sequence the code number 0,0,9,3,5. The
    POWER key will flash twice after the first 0 and then
    flash twice again after the final 5 to confirm a successful
    code entry.


Doesn't it just suck that you have to pry this info from Mitsubishi? Why can't they just put it in the darn manaul.....


Hosting Services by ipHouse