Your Universal Remote Control Center
RemoteCentral.com
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 3 made on Friday June 11, 2021 at 23:19
JonSS
Long Time Member
Joined:
Posts:
August 2003
46
On June 5, 2021 at 14:58, Duct Tape said...
i'd check for RF interference since that is almost always the cause of issues with the MRF350.

start by setting your dial on the bottom to zero (if it's already at zero, then that is an issue).  Once it is set to zero, look at the status lights on the RFX250 antenna.  If the status light is blinking without pressing buttons on the remote, you are getting interference.  Find a location for the antenna that doesn't blink the RF status light.  Then turn the dial back to match what is in your programming file.

Next step, do you have your IR routing set up correctly or do you just have it set to all outputs for your emitters?

next step if the above items don't help.

try setting the IR routing to be IR only from the remote.  Point your remote at the devices.  Does it control the devices correctly?

Thanks, it did turn out to RF interference, not sure where it came from all of a sudden. Strange that moving it 1 cm makes so much difference and so random. I ended putting a ferrite coil at the bottom of the antenna and it also seemed to help a lot. Hopefully things should be ok now.


Hosting Services by ipHouse