Post 14 made on Wednesday January 1, 2020 at 14:38 |
freddy Long Time Member |
Joined: Posts: | October 2004 33 |
|
|
Lyndel,
Thanks. Finally getting back to this.
I set it up as you describe on the System Properties - Network tab, and I went to each component used in the project and made sure the box was checked next to the extender.
When I try it out, 'Command Failed' shows at the top of the remote.
I do not see RF in the top right of the display (this is different than before).
Interestingly when I try the simulator RF does show... but 'Command Failed' still happens.
Appreciate any suggestions...
|
|
|