Your Universal Remote Control Center
RemoteCentral.com
Crestron Control Systems Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 7 made on Sunday March 25, 2018 at 23:38
wagkyf
Lurking Member
Joined:
Posts:
March 2018
6
On March 23, 2018 at 11:58, SWOInstaller said...
Does your company have the programs for all the processors? Without these programs there would be no way that this company that did the upgrades could know how the old system was running. If equipment stopped working after the upgrades I don't believe these processors were programmed as Master and Slaves instead programmed with intersystems. To save wiring a processor would have been installed on different floors/areas of the building and would communicate to each other over the network.

The error light could be a lot of different issues. However, if it wasn't on before the upgrades were completed I would guess that these systems were programmed as above using inter-system communication and now that one processor is missing an error will be reported as it has lost communication with the removed processor.

Again, without the actual programs (simpl files) there would be no way to know exactly what is going on.

update: I went in today and tested out the problems. I was able to get audio to play in some of the zones but wasnt able to get it to play in the most important two zones. For some reason, the tps-4l touchpad volume controls are sporadic and often slow. I also found that some devices have duplicate IDs ( A touchpad and a slave controller have ID of 0B, Two QM-AE have ID of 10), I suppose this is causing some problems... Would someone ever have two same IDs for any reason? Could that be causing slow response times? Or could the system just be old and slow...


Hosting Services by ipHouse