Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 18 made on Monday June 19, 2017 at 14:11
Lurking Member
June 2017
Hi All

I bought an existing MX-900 from a house I that bought. I requested the programming software from URC and they send me the "MX-900 Editor."

However as I tried to download (put a new program into MX900) I get a message "MX-900 Editor us unable to download to the remote. It was previously programmed with a newer version of the software."

Also when I tried to upload (get the remote's program) I get this message that "MX-900 Editor cannot open this file. It was created with a newer version of Software. You need to use CCP (Complete Control Program)"

So can I do a factory reset of this remote and then it will allow me to program it?


Hosting Services by ipHouse