Your Universal Remote Control Center
Original Equipment Remotes Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Wednesday June 7, 2017 at 13:50
Lurking Member
June 2017
I just switched providers from directv to cox and trying to setup the XR11 voice remote to control my Emotiva UMC-1 receiver. I can get it to power off with the code provided in the setup 33763. The problem is that is all it does. I get volume commands that blink on the receiver but no volume changes, or power on from the XR11 remote. I have tried all other codes provided, 34102, 34101, 34100, and 34059 but, none of these have any response to the receiver. It seems as if the remote is sending the wrong codes to the receiver to get the correct output. Is there anything I can do to get this to work, or learn the correct codes from the oe metal remote?



Hosting Services by ipHouse