Your Universal Remote Control Center
General Consumer Remotes Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Wednesday December 10, 2014 at 22:50
Lurking Member
December 2014
I have recently purchased a Sanyo DP58D33 TV and I have been struggling with finding the discrete codes for the specific inputs (if any). I have an OneForAll URC-6131 that I program using Remote Master and the IR.exe program. I have run through a couple NEC1 protocols but after a a few hundred I am at a loss.

Any help with the correct protocol, device number, and any discrete codes that are known would be fantastic. Unfortunately after a few hours of searching there does not appear to be any current information that applies to Sanyo TVs in the last few years that reference discrete input selection.

Thanks you in advance for any help that you can provide.

Hosting Services by ipHouse