Your Universal Remote Control Center
Complete Control by URC Forum - View Post
Up level
Up level
The following page was printed from


Original thread:
Post 1 made on Thursday September 27, 2012 at 20:58
Sonnie Parker
Founding Member
December 2001
I guess I am losing it with this CCP software. I swapped out a Dish receiver 612 for a 722 that I had a Power On and Power Off macro programmed on the main power on and off buttons. After copying the discrete on and off commands from the IR database to the Sat device page 4, the buttons work, but I cannot seem to get them to work in the macro. I don't remember ever having this issue in the past and have programmed dozens of these, swapped out several receivers, etc, etc, but obviously something has changed or I am losing my mind. Is there particular reason the button will not work inside the macro?  Thanks!

Hosting Services by ipHouse