Your Universal Remote Control Center
RemoteCentral.com
Philips Pronto Classic Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 1 made on Friday June 15, 2012 at 11:56
Loftboy
Long Time Member
Joined:
Posts:
February 2009
35
I seem to have a big problem with one of my RC9200s. I removed the battery yesterday to use in it in another remote. When I replaced it the remote would no longer work. The remote seems to be in a reboot cycle, but it's not a straightforward case. I've tried using hyperterminal to revive it but to no avail - the process of sending the file to the remote all seems to work fine - CABERNET prompt, dl ccf send etc, but when I type "go" - no joy. The remote just continues to reboot emitting a couple of light ticks every few seconds (no loud beep) and the screen is pretty much blank.

The remote was working perfectly right up until I refitted the battery.

Help very much appreciated.................

Just a thought - I did not transfer the "default ccf" to the RC9200 - just my own ccf - does this make a difference? If so, I don't have the default ccf - where can I find the default ccf - I've searched without success - a link would be great - thanks

Last edited by Loftboy on June 15, 2012 12:44.


Hosting Services by ipHouse