Your Universal Remote Control Center
RemoteCentral.com
Blu-ray & DVD Forum - View Post
Up level
Up level
The following page was printed from RemoteCentral.com:

Login:
Pass:
 
 

Original thread:
Post 1 made on Sunday September 26, 2010 at 19:11
Debbie25
Long Time Member
Joined:
Posts:
March 2004
172
I'm not getting TV channels from my HD/DVD player to my TV.
Cable line is in the coax input.
Component cable from players output to TV input.

I have my cable line from the wall to the player and not going through a cable box and have gone through the setup on the player stating that it is connected to cable service but not a cable box.

I can get TV channels within the TV guide just fine in the upper left hand corner but full screen is blank.
When I start up a DVD disk, I get video fine.
Then when I turn the DVD disk off I will get a TV channel until I try to turn the channel and then the screen goes blank.

Iím also not getting any TV guide lineup at all.

Not sure what is going on here.

Any answers out there?

Thanks,
Debbie

Last edited by Debbie25 on September 26, 2010 19:36.


Hosting Services by ipHouse